Products Center
Active and Reactive Frequency Table (Conventional)
- Contact Us
- Tel£º+8613362703406
- Email£ºtk@chtkdz.com
- Url£ºhttp://www.chtkdz.com
2. Optional with communication function, communication address, baud rate
3. Software adjustment, no internal potentiometer, high precision
4. Software adjustment, no internal potentiometer, high precision
1. Before use, the meter needs to be powered on for 15 minutes.
2. Pay attention to prevent vibration and impact, and do not use it in places with excess dust and excess harmful gases.
3. The input wire should not be too long. If the input end of the signal under test is long, please use a twisted pair shielded wire.
4. If the signal is accompanied by high frequency interference, a low frequency filter should be used in the line.
5. When not in use for a long time, please turn on the power for no less than 4 hours every three months.
6. Long-term storage should avoid direct light, and should be stored at -10¡æ~70¡æ.
7. If there is no display on the meter, first check the auxiliary power supply to see if the voltage is within the specified range.
8. If the display is abnormal, check whether the input signal is normal and whether the signal terminals are tightened.
9. Unless the PT has enough power, the PT signal cannot be used as an auxiliary power supply at the same time to ensure the normal operation of the instrument.
10. The screws of the current terminals in the CT circuit must be tightened to ensure reliable contact between the incoming and outgoing wires to avoid malfunctions.
|
product name |
product model |
basic function |
remarks |
|
|
Three-phase active power meter |
CHTK900P-2Kl |
|
Three-phase active power A row of LED digital tubes shows the display True effective value measurement, the whole four-digit display Optional band with communication function, optional band The analog volume outputs either DC4-20mA or 0-20mA, Alarm output. Protable table arbitrary through panel buttons Adjust the display value 1~9999, software Adjustment, high precision, long-term work without adjustment. |
Open hole is 111mm * 111mm |
|
CHTK900P-9Kl |
Open hole is 91mm * 91mm |
|||
|
CHTK900P-1Kl |
|
Open hole is 152mm * 76mm |
||
|
CHTK900P-4Kl |
Open hole is 115mm * 56mm |
|||
|
CHTK900P-5Kl |
Open hole is 91mm * 45mm |
|||
|
three phase varmeter |
CHTK900Q-2Kl |
|
Three-phase reactive power A row of LED digital tubes shows the display True effective value measurement, the whole four-digit display Optional band with communication function, optional band The analog volume outputs either DC4-20mA or 0-20mA, Alarm output. Protable table arbitrary through panel buttons Adjust the display value 1~9999, software Adjustment, high precision, long-term work without adjustment. |
Open hole is 111mm * 111mm |
|
CHTK900Q-9Kl |
Open hole is 91mm * 91mm |
|||
|
CHTK900Q-1Kl |
|
Open hole is 152mm * 76mm |
||
|
CHTK900Q-4Kl |
Open hole is 115mm * 56mm |
|||
|
CHTK900Q-5Kl |
Open hole is 91mm * 45mm |
|||
|
product name |
Product model |
basic function |
remarks |
|
|
Single-type three-phase power factor table |
CHTK900H-2Kl |
|
A row of LE D digital tubes is on display Single and three-phase phases can be set through the panel buttons Display range: C0.000~1.000~LO.000 Software tuning, internal no potentiometer, high accuracy is optional with communication function.(Should be indicated when ordering) with optional upper and lower limit alarm control function |
Open hole is 111mm * 111mm |
|
CHTK900H-9Kl |
Open hole is 91mm * 91mm |
|||
|
CHTK900H-3Kl |
Open hole is 76mm * 76mm |
|||
|
CHTK900H-AK1 |
Open hole is 68mm * 68mm |
|||
|
CHTK900H-5Kl |
|
Open hole is 91mm * 45mm |
||
|
CHTK900H-1Kl |
Open hole is 151mm * 71mm |
|||
|
CHTK900H-4Kl |
Open hole is 115mm * 56mm |
|||
|
Frequency Table CHTK900F tachometer CHTK900N Pressure gauge: CHTK900N Weight gauge: CHTK900N Special table et al. CHTK900N |
CHTK900F(N)-2Kl |
|
A row of LED digital tubes shows that, Various input signals, For example, there are: DC4-20MA, DC0-20MA,DC10V,DC75MV So on programmable through the panel button Any adjustment display value 1~9999, The whole four-display, optional belt up and down Limited alarm control function, optional with variable transmission Output, optional with communication function. |
Open hole is 111mm * 111mm |
|
CHTK900F(N)-9Kl |
Open hole is 91mm * 91mm |
|||
|
CHTK900F(N)-3Kl |
Open hole is 76mm * 76mm |
|||
|
CHTK900F(N)-AK1 |
Open hole is 68mm * 68mm |
|||
|
CHTK900F(N)-5Kl |
|
Open hole is 91mm * 45mm |
||
|
CHTK900F(N)-1Kl |
Open hole is 151mm * 71mm |
|||
|
CHTK900F(N)-4Kl |
Open hole is 115mm * 56mm |
|||
|
CHTK900F(N)-DK1 |
|
Open hole is 45mm * 45mm |
||
